Ricoh M160 Service Manual page 709

No Function
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on the
3 error report
0: No 1: Yes
Power failure report
5 0: Disabled
1: Enabled (default)
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types of
remote terminal ID when
printing reports
7 0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI
> CSI
M160/M161 Fax Option
System Switch 09 (SP No. 1-101-010)
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which
occurs rarely.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.

This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.

This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored, by the user, for
the Quick/Speed Dial number.
53
Comments
If "0" is selected, no reports are printed
and no one may recognize that fax
data is gone due to a power failure.
The memory size is limited. Use this
bit switch only when some log reports
are necessary.
Bit Switches - 1
SM