Performing lung function tests
Operator's Manual V5.0 • EasyOne Pro/LAB Rev. 05
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
3 Tell the patient to exhale as hard and as fast as possible and to continue
blowing out until the lungs are completely empty.
4 When the message Manually End Test is displayed, you can choose the
Button
End Test
at your discretion.
You can configure manual test stop or automatic test stop under
Utilities > Configuration > Test > General > Test
The test result is displayed.
5 Tell the patient to take the spirette out of the mouth and to breathe
normally again.
If the trial is acceptable, the green quality message is displayed.
If the trial is not acceptable, a yellow or red quality message is
displayed suggesting how to improve the breathing maneuver.
To add trials
1 Choose
Add
Trial.
2 Repeat the previous procedure To perform the FVC breathing maneuver
and this procedure To add trials until the green Session Complete!
message is displayed.
In the
Test Information
3 Do the following:
a) Review the test quality that is displayed in the
b) Decide whether the test quality is sufficient or not.
c) If necessary, add a trial and repeat the previous procedure To perform
the FVC breathing maneuver.
To end the test
1 Grip the spirette with the wrapper again and pull the spirette out of the
spirette holder. Do not touch the spirette.
2 Dispose of the spirette together with the wrapper.
Procedure.
area the quality grade for the test is displayed.
Test Information
area.
93
56/171