Introduction
Operator's Manual V5.0 • EasyOne Pro/LAB Rev. 05
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
3 Insert the flow sensor holder into the side of EasyOne Pro/LAB. (C)
You can pull out the holder for use. The holder snaps in at a certain
point. You can slide in the holder when not in use.
4 On the side of EasyOne Pro/LAB, unscrew the dust cap.
Keep the dust cap in case you want to put EasyOne Pro/LAB in storage
at a later point in time.
5 With the purple end, connect the patient tube to EasyOne Pro/LAB. (D)
35
22/171