NDD EasyOne Pro Operator's Manual page 121

Configuration
Operator's Manual V5.0 • EasyOne Pro/LAB Rev. 05
© ndd Medizintechnik AG • Technoparkstrasse 1, 8005 Zurich, Switzerland • www.ndd.ch
3 Do the following:
a) Choose Utilities > Configuration > Test >
b) Make sure that the gas concentrations of your gas supply match the
values that you have entered here before.
c) If the Automatic Discard Volume
check box and choose OK.
4 If any of the above checks are negative, contact your EasyOne dealer or the
ndd Servicing Department.
5 If all of the above checks are positive, proceed with the postrequisite.
Postrequisite
CAUTION
FAILED UPDATE
An update may fail unnoticed.
After performing an update, restart EasyOne Pro/LAB and EasyOne Connect
and perform a calibration check.
Calibration check, 122
Checking for correct operation of EasyOne Pro/LAB, 127
 Contact information, 4
DLCO.
check box is not selected, select this
121
121/171