Table 8-34 Ge_Xp And 10Ge_Xp Card-Level Indicators - Cisco ONS 15454 DWDM Reference Manual

Chapter 8 Transponder and Muxponder Cards
Figure 8-26
8.11.9 GE_XP and 10GE_XP Card-Level Indicators
Table 8-34
Table 8-34
Card-Level LED
Red FAIL LED
ACT LED
Green (Active)
Amber SF LED
78-18343-02
GE_XP and 10GE_XP Layer 2 Over DWDM Provisioning > Protection Tab
describes the three card-level LEDs on the GE_XP and 10GE_XP cards.
GE_XP and 10GE_XP Card-Level Indicators
Description
The red FAIL LED indicates that the card's processor is not ready. This LED
is on during reset. The FAIL LED flashes during the boot process. Replace the
card if the red FAIL LED persists.
If the ACT LED is green, the card is operational (one or more ports active) and
ready to carry traffic.
The amber SF LED indicates that a signal failure or condition such as LOS,
LOF, or high BERs is present one or more of the card's ports. The amber SF
LED is also on if the transmit and receive fibers are incorrectly connected. If
the fibers are properly connected and the link is working, the light turns off.
8.11.9 GE_XP and 10GE_XP Card-Level Indicators
Cisco ONS 15454 DWDM Reference Manual, R8.5
8-67