Figure 8-23 Mxp_Mr_10Dme_C And Mxp_Mr_10Dme_L Faceplates And Block Diagram; Wavelength Identification - Cisco ONS 15454 DWDM Reference Manual

Hide thumbs Also See for ONS 15454 DWDM:

Table of Contents

Transponder and Muxponder Cards

MXP_MR_10DME_C and MXP_MR_10DME_L Faceplates and Block Diagram

For information on safety labels for the cards, see the

You must use a 20-dB fiber attenuator (15 to 25 dB) when working with the cards in a loopback on the

trunk port. Do not use direct fiber loopbacks with the cards. Using direct fiber loopbacks causes

irreparable damage to the MXP_MR_10DME_C and MXP_MR_10DME_L cards.

The card uses trunk lasers that are wavelocked, which allows the trunk transmitter to operate on the ITU

grid effectively. Both the MXP_MR_10DME_C and MXP_MR_10DME_L cards implement the UT2

module. The MXP_MR_10DME_C card uses a C-band version of the UT2 and the

MXP_MR_10DME_L card uses an L-band version.

2M x 36bit Burst4

"8.2.2 Class 1M Laser Product Cards" section on

Cisco ONS 15454 DWDM Reference Manual, R8.5

8.10.3 Wavelength Identification

Power supply

Chapters

Table of Contents