Figure 1-7 Ons 15454 Two-Channel Optical Add/Drop Flexlayer Module; Figure 1-8 Two-Channel Drop Component Connector Mapping And Labeling - Cisco ONS 15454 DWDM Reference Manual

1.4.1 FlexLayer Modules
Figure 1-7
Figure 1-7 ONS 15454 Two-Channel Optical Add/Drop FlexLayer Module
Front Panel
Labels are provided to show how the module ports are mapped. It is the end user's responsibility to label
the module for its intended use (drop or add component).
Figure 1-8
used as a drop component. The COM-RX is mapped to Port 1, the COM-TX is mapped to Port 12, and
the two dropped channel TX ports are mapped to Ports 9 and 10. The two-percent tap MON port is
mapped to Port 6. Port 7 is not active.
Figure 1-8
Figure 1-9
used as an add component. The COM-TX is mapped to Port 1, the COM-RX is mapped to Port 12, and
the added channels are mapped to the two RX Ports 9 and 10. The two-percent tap MON port is mapped
to Port 7. Port 6 is not active.
Cisco ONS 15454 DWDM Reference Manual, R8.5
1-12
shows the physical appearance of the ONS 15454 two-channel add/drop FlexLayer module.
shows how the connectors are mapped and labeled on the front panel when the component is
Two-Channel Drop Component Connector Mapping and Labeling
2 Channel Drop Module 15216-FLB-2-XX.X
COM-RX
2% TAP
1
6 9 10
15XX.XX 15XX.XX
MON
TX TX
shows how the connectors are mapped and labeled in the front panel when the component is
COM-TX
12
Chapter 1 Shelf Assembly Hardware
78-18343-02