Table 4-10 Opt-Bst-L Card-Level Indicators - Cisco ONS 15454 DWDM Reference Manual

Chapter 4 Optical Amplifier Cards
Table 4-9
Photodiode
P2
P3
P4
P5
For information on the associated TL1 AIDs for the optical power monitoring points, refer the "CTC
Port Numbers and TL1 Aids" section in Cisco ONS SONET TL1 Command Guide, Release 8.5.
4.6.4 OPT-BST-L Card-Level Indicators
Table 4-10
Table 4-10
Card-Level Indicators
Red FAIL LED
Green ACT LED
Amber SF LED
4.6.5 OPT-BST-L Port-Level Indicators
You can determine the status of the card ports using the LCD screen on the ONS 15454 fan-tray
assembly. Use the LCD to view the status of any port or card slot; the screen displays the number and
severity of alarms for a given port or slot.
4.7 OPT-AMP-L Card
For hardware specifications, see the
Note
page
For OPT-AMP-L card safety labels, see the
Note
78-18343-02
OPT-BST-L Port Calibration (continued)
CTC Type Name
Output Line (Total Output)
Output Line (Signal Output)
Output OSC-RX
Output COM
Output OSC-TX
shows the three card-level LEDs on the OPT-BST-L card.
OPT-BST-L Card-Level Indicators
Description
The red FAIL LED indicates that the card's processor is not ready or that an
internal hardware failure occurred. Replace the card if the red FAIL LED
persists.
The green ACT LED indicates that the OPT-BST-L is carrying traffic or is
traffic-ready.
The amber SF LED indicates a signal failure or condition such as LOS on
one or more of the card's ports. The amber SF LED also turns on when the
transmit and receive fibers are incorrectly connected. When the fibers are
properly connected, the light turns off.
A-17.
Calibrated to Port
LINE TX
OSC-RX
LINE RX
"A.5.5 OPT-AMP-L Preamplifier Card Specifications" section on
"4.2 Class 1M Laser Safety Labels" section on page
Cisco ONS 15454 DWDM Reference Manual, R8.5
4.6.4 OPT-BST-L Card-Level Indicators
4-3.
4-21