Interlink Interfaces - Cisco ONS 15454 DWDM Reference Manual

8.12.6 Interlink Interfaces

•
8.12.6 Interlink Interfaces
Two 2R interlink interfaces, called ILK1 and ILK2, are automatically created on each ADM-10G card
and placed in the IS/Unlocked service state. Physically cabling these ports between two ADM-10G
cards, located on the same shelf, allows you to configure them as an ADM Peer Group.The ILK ports
carry 10G of traffic each.
The interlink interfaces support the following STM64 SR1 (ONS-XC-10G-S1=) XFP:
8.12.7 DWDM Trunk Interface
The ADM-10G card supports OC-192/STM-64 signal transport and ITU-T G.709 digital wrapper
according to the ITU-T G.709 standard. It supports one DWDM trunk XFP at a time in a double-slot
configuration.
The supported DWDM trunk XFPs are:
•
•
8.12.8 Configuration Management
When using OC-48/STM-16 traffic, some contiguous port configurations, listed in
unavailable due to hardware limitations. This limitation does not impact the Gigabit Ethernet payload.
The ADM-10G card cannot be used in the same shelf with SONET or SDH cross-connect cards.
Note
Table 8-36
OC-48/STM-16 Port Number
OC-48/STM-16 on Port 13
OC-48/STM-16 on Port 14
OC-48/STM-16 on Port 15
OC-48/STM-16 on Port 16
The total traffic rate for each trunk cannot exceed OC-192/STM-64 on each ADM-10G card, or for each
Note
ADM peer group.
Cisco ONS 15454 DWDM Reference Manual, R8.5
8-72
xx.x = 28.7 to 60.6. ONS-SC-2G-28.7, ONS-SC-2G-33.4, ONS-SC-2G-41.3,
Note
ONS-SC-2G-49.3, and ONS-SC-2G-57.3 are supported from Release 8.5 and later.
CWDM SFPs
OC48/STM16/GE CWDM SFP (ONS-SC-Z3-xxxx)
–
10G DWDM (ONS-XC-10G-xx.x=) (colored XFP)
STM64 SR1 (ONS-XC-10G-S1=) (gray XFP)
OC-48/STM-16 Configuration Limitations
Chapter 8
Ports Restricted from Optical Traffic
No OC-N/STM-N on Port 1 through Port 3
No OC-N/STM-N on Port 4 through Port 6
No OC-N/STM-N on Port 7 through Port 9
No OC-N/STM-N on Port 10 through Port 12
Transponder and Muxponder Cards
Table 8-36, are
78-18343-02