Table 6-17 Ad-4B-Xx.x Port Calibration; Table 6-18 Ad-4B-Xx.x Card-Level Indicators - Cisco ONS 15454 DWDM Reference Manual

6.7.2 AD-4B-xx.x Card-Level Indicators
Table 6-17
Photodiode
P1–P4
P5–P8
P9
P10
P11
V1
For information on the associated TL1 AIDs for the optical power monitoring points, refer the "CTC
Port Numbers and TL1 Aids" section in Cisco ONS SONET TL1 Command Guide, Release 8.5.
6.7.2 AD-4B-xx.x Card-Level Indicators
The AD-4B-xx.x card has three card-level LED indicators, described in
Table 6-18
Card-Level Indicators
Red FAIL LED
Green ACT LED
Amber SF LED
6.7.3 AD-4B-xx.x Port-Level Indicators
You can find the status of the card port using the LCD screen on the ONS 15454 fan-tray assembly. Use
the LCD to view the status of any port or card slot; the screen displays the number and severity of alarms
for a given port or slot. The AD-4B-xx.x has 12 LC-PC-II optical ports: eight for add/drop band client
input and output, two for express channel input and output, and two for communication.
Cisco ONS 15454 DWDM Reference Manual, R8.5
6-26
AD-4B-xx.x Port Calibration
CTC Type Name
ADD
DROP
IN EXP
OUT EXP
IN COM
OUT COM
AD-4B-xx.x Card-Level Indicators
Description
The red FAIL LED indicates that the card's processor is not ready or that
there is an internal hardware failure. Replace the card if the red FAIL LED
persists.
The green ACT LED indicates that the AD-4B-xx.x card is carrying traffic
or is traffic-ready.
The amber SF LED indicates a signal failure. The amber SF LED also
illuminates when the transmit and receive fibers are incorrectly connected.
When the fibers are properly connected, the light turns off.
Chapter 6
Calibrated to Port
COM TX
DROP TX
EXP RX
EXP TX
COM RX
COM TX
Table
Optical Add/Drop Cards
6-18.
78-18343-02