Figure 4-4 Fda Statement Label; Figure 4-5 Shock Hazard Label - Cisco ONS 15454 DWDM Reference Manual

Chapter 4 Optical Amplifier Cards
Figure 4-4
COMPLIES WITH 21 CFR 1040.10
4.2.5 Shock Hazard Label
Figure 4-5
The potential for shock exists when you remove adjacent cards during maintenance or touch exposed
electrical circuity on the card.
Figure 4-5
4.3 OPT-PRE Amplifier Card
Note For hardware specifications, see the
page
Note For OPT-PRE card safety labels, see the
The OPT-PRE is a C-band, DWDM, two-stage erbium-doped fiber amplifier (EDFA) with midamplifier
loss (MAL) that can be connected to a dispersion compensating unit (DCU). The OPT-PRE is equipped
with a built-in variable optical attenuator (VOA) that controls the gain tilt and can also be used to pad
the DCU to a reference value. You can install the OPT-PRE in Slots 1 to 6 and 12 to 17. The card is
designed to support up to 80 channels at 50-GHz channel spacing. The OPT-PRE features include:
•
•
•
•
•
78-18343-02
FDA Statement Label
AND 1040.11 EXCEPT FOR
DEVIATIONS PURSUANT TO
LASER NOTICE NO.50,
DATED JULY 26, 2001
shows the Shock Hazard label. This label alerts you to an electrical hazard within the card.
Shock Hazard Label
A-14.
Fixed gain mode with programmable tilt
True variable gain
Fast transient suppression
Nondistorting low-frequency transfer function
Settable maximum output power
"A.5.1 OPT-PRE Amplifier Card Specifications" section on
"4.2 Class 1M Laser Safety Labels" section on page
Cisco ONS 15454 DWDM Reference Manual, R8.5
4.2.5 Shock Hazard Label
4-3.
4-5