Table 8-3 Txp_Mr_10G Card-Level Indicators - Cisco ONS 15454 DWDM Reference Manual

Chapter 8 Transponder and Muxponder Cards
8.3.2 TXP_MR_10G Card-Level Indicators
Table 8-3
Table 8-3
Card-Level LED
FAIL LED (Red)
ACT/STBY LED
Green (Active)
Amber (Standby)
SF LED (Amber)
8.3.3 TXP_MR_10G Port-Level Indicators
Table 8-4
Table 8-4
Port-Level LED
Green Client LED
Green DWDM LED
Green Wavelength 1
LED
Green Wavelength 2
LED
8.4 TXP_MR_10E Card
The TXP_MR_10E card is a multirate transponder for the ONS 15454 platform. The card is fully
backward compatible with the TXP_MR_10G card. It processes one 10-Gbps signal (client side) into
one 10-Gbps, 100-GHz DWDM signal (trunk side) that is tunable over four wavelength channels (spaced
at 100 GHz on the ITU grid) in the C band and tunable over eight wavelength channels (spaced at 50 GHz
on the ITU grid) in the L band. There are eight versions of the C-band card, with each version covering
four wavelengths, for a total coverage of 32 wavelengths. There are five versions of the L-band card,
with each version covering eight wavelengths, for a total coverage of 40 wavelengths.
78-18343-02
lists the three card-level LEDs on the TXP_MR_10G card.
TXP_MR_10G Card-Level Indicators
Description
Red indicates that the card's processor is not ready. This LED is on during
reset. The FAIL LED flashes during the boot process. Replace the card if the
red FAIL LED persists.
Green indicates that the card is operational (one or both ports active) and
ready to carry traffic.
Amber indicates that the card is operational and in standby (protect) mode.
Amber indicates a signal failure or condition such as loss of signal (LOS),
loss of frame (LOF), or high bit error rates (BERs) on one or more of the
card's ports. The amber SF LED is also illuminated if the transmit and
receive fibers are incorrectly connected. If the fibers are properly connected
and the link is working, the LED turns off.
lists the four port-level LEDs in the TXP_MR_10G card.
TXP_MR_10G Port-Level Indicators
Description
The green Client LED indicates that the client port is in service and that it is
receiving a recognized signal.
The green DWDM LED indicates that the DWDM port is in service and that
it is receiving a recognized signal.
Each port supports two wavelengths on the DWDM side. Each wavelength
LED matches one of the wavelengths. This LED indicates that the card is
configured for Wavelength 1.
Each port supports two wavelengths on the DWDM side. Each wavelength
LED matches one of the wavelengths. This LED indicates that the card is
configured for Wavelength 2.
8.3.2 TXP_MR_10G Card-Level Indicators
Cisco ONS 15454 DWDM Reference Manual, R8.5
8-11