Fec Pm Parameter Definitions - Cisco ONS 15454 DWDM Reference Manual

Chapter 17 Performance Monitoring
Table 17-27
Parameter
ifInJunkInterPkts
ifInMulticastPkts
ifInOctets
ifOutBroadcastPkts
ifOutDiscards
ifOutMulticastPkts
ifOutOctets
InvalidCRCError
mediaIndStatsRxFramesBadCRC
mediaIndStatsRxFramesTooLong
mediaIndStatsRxFramesTruncated
mediaIndStatsTxFramesBadCRC
Running Disparity Count
rxControlFrames
rxFrames
rxLinkReset (Only for FC Mode)
rxPauseFrames
rxTotalPkts
rxUnknownOpcodeFrames
Time Last Cleared
txBytes
txFrames
txTotalPkts

17.7 FEC PM Parameter Definitions

Table 17-28
TXP_MR_10E_L card FEC PM parameters. For more information, see the
Muxponder Card Performance Monitoring" section on page
78-18343-02
Full RMON Statistics PM Definitions (continued)
Definition
The number of interpacket gaps between valid start symbols
during which a symbol other than idle is detected, including
packets of length 1–8 octets.
The total number of multicast frames received error-free.
The number of bytes received since the last counter reset.
The number of packets requested by higher-level protocols and
addressed to a broadcast address at this sublayer, including those
not transmitted.
The number of outbound packets that were chosen to be
discarded even though no errors had been detected to prevent
their being transmitted. One possible reason for discarding such
a packet could be to free buffer space.
The number of multicast frames transmitted error-free.
The number of bytes transmitted since the last counter reset.
A count of invalid cyclic redundancy checks (CRCs).
The number of received frames with a CRC error.
The number of received frames that are too long.
The number of received frames that are too small.
The number of transmitted frames with a CRC error.
A count of errors that affect the disparity of the received data
stream.
The number of MAC control packets that are type 0x8808 and
contain at least 64 octets in length.
A count of the number of frames received without errors.
A count of the received link resets.
The number of received 802.x paused frames.
The number of received packets.
Number of packets of at least 64 octets in length and type
0x8808, with opcode not equal to 1.
A time stamp indicating the last time statistics were reset.
A count of the number of bytes transmitted from the frame since
the last counter reset.
A count of the number of transmitted frames.
The number of transmitted packets.
defines the MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_10E, TXP_MR_10E_C, and
17.7 FEC PM Parameter Definitions
"17.2 Transponder and
17-2.
Cisco ONS 15454 DWDM Reference Manual, R8.5
17-25