Figure 15-6 Scenario 5: Static Route With One Ctc Computer Used As A Destination (Ansi And Etsi) - Cisco ONS 15454 DWDM Reference Manual

Chapter 15 Management Network Connectivity
Figure 15-6 Scenario 5: Static Route With One CTC Computer Used as a Destination (ANSI and ETSI)
LAN A
CTC Workstation
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
Default Gateway = 192.168.1.1
Host Routes = N/A
ONS 15454 #2
IP Address 192.168.3.20
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
The destination and subnet mask entries control access to the ONS 15454s:
•
•
•
The IP address of router interface B is entered as the next hop, and the cost (number of hops from source
to destination) is 2.
78-18343-02
Router
IP Address of interface "A" to LAN "A" 192.168.1.1
IP Address of interface "B" to LAN "B" 192.168.2.1
Subnet Mask 255.255.255.0
Int "A"
Int "B"
ONS 15454 #1
IP Address 192.168.2.10
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes
Ring
If a single CTC computer is connected to a router, enter the complete CTC "host route" IP address
as the destination with a subnet mask of 255.255.255.255.
If CTC computers on a subnet are connected to a router, enter the destination subnet (in this example,
192.168.1.0) and a subnet mask of 255.255.255.0.
If all CTC computers are connected to a router, enter a destination of 0.0.0.0 and a subnet mask of
0.0.0.0. Figure 15-7 shows an example.
15.2.5 Scenario 5: Using Static Routes to Connect to LANs
Destination 192.168.1.0
Mask 255.255.255.0
Next Hop 192.168.2.1
Cost = 2
ONS 15454 #3
IP Address 192.168.4.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
Cisco ONS 15454 DWDM Reference Manual, R8.5
LAN B
15-9