Table 12-3 Ons 15454 Connection Methods - Cisco ONS 15454 DWDM Reference Manual

Chapter 12 Cisco Transport Controller Operation
12.4 ONS 15454 Connections
You can connect to the ONS 15454 in multiple ways. You can connect your PC directly to the
ONS 15454 (local craft connection) using the RJ-45 port on the TCC2/TCC2P card or, for the ANSI
shelf, using the LAN pins on the backplane (the ETSI shelf provides a LAN connection via the RJ-45
jack on the MIC-T/C/P Front Mount Electrical Connection [FMEC]). Alternatively, you can connect
your PC to a hub or switch that is connected to the ONS 15454, connect to the ONS 15454 through a
LAN or modem, or establish TL1 connections from a PC or TL1 terminal.
15454 connection methods and requirements.
Table 12-3
Method
Local craft Refers to onsite network connections
Corporate
LAN
78-18343-02
ONS 15454 Connection Methods
Description
between the CTC computer and the
ONS 15454 using one of the following:
The RJ-45 (LAN) port on the
•
TCC2/TCC2P card
The RJ-45 (LAN) port on the patch panel
•
(multishelf mode)
Port 23 or 24 of the Catalyst 2950
•
(multishelf mode)
The LAN pins on the ONS 15454
•
backplane (ANSI)
The RJ-45 jack on the MIC-T/C/P
•
FMEC (ETSI)
A hub or switch to which the ONS 15454
•
is connected
Refers to a connection to the ONS 15454
through a corporate or network operations
center (NOC) LAN.
12.4 ONS 15454 Connections
Table 12-3
Requirements
If you do not use Dynamic Host
Configuration Protocol (DHCP), you must
change the computer IP address, subnet
mask, and default router, or use automatic
host detection.
The ONS 15454 must be provisioned
•
for LAN connectivity, including IP
address, subnet mask, and default
gateway.
• The ONS 15454 must be physically
connected to the corporate LAN.
The CTC computer must be connected
•
to the corporate LAN that has
connectivity to the ONS 15454.
Cisco ONS 15454 DWDM Reference Manual, R8.5
lists the ONS
12-7