Dnp User Point List - GE D90 Plus Instruction Manual

Line distance protection system

Hide thumbs Also See for D90 Plus:

Table of Contents

DNP COMMUNICATIONS

DNP user point list

Points not configured as paired operate on a one-to-one basis.

DNP TCP Connection Timeout

Range: 10 to 300 seconds in steps of 1

Default: 120 seconds

This setting specifies a time delay for the detection of dead network TCP connections. If

there is no data traffic on a DNP TCP connection for greater than the time specified by

this setting, the connection will be aborted by the D90

to be re-used by a client.

Power to the D90

must be re-cycled after changing this setting for the changes to take

The binary and analog inputs points for the DNP protocol can configured to a maximum of

256 points. The value for each point is user-programmable and can be configured by

assigning FlexLogic™ operands for binary inputs or FlexAnalog™ parameters for analog

The DNP point lists always begin with point 0 and end at the first "Off" value. Since DNP

point lists must be in one continuous block, any points assigned after the first "Off" point

are ignored. Changes to the DNP point lists will not take effect until the D90

Select the Settings > Communications > DNP > User Point List menu item to open the

DNP user point list configuration window.

Figure 86: DNP user point list configuration settings

The following settings are available for points 0 through 255.

Figure 85: Paired points list

LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL

CHAPTER 6: COMMUNICATIONS

. This frees up the connection

is restarted.