Remaining Tcp/Ip Connections Actual Values - GE D90 Plus Instruction Manual

CHAPTER 6: COMMUNICATIONS

Remaining TCP/IP connections actual values

PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Configure IP Network Status
Range: OK, PORT 1 NETMASK ERROR, PORT 2 NETMASK ERROR, PORT 3 NETMASK ERROR,
PORT 1 IP ADDR RSVD, PORT 2 IP ADDR RSVD, PORT 3 IP ADDR RSVD, PORT 1 IP ADDR
LPBK, PORT 2 IP ADDR LPBK, PORT 3 IP ADDR LPBK, PORT 1 IP ADDR NETWK, PORT 2 IP
ADDR NETWK, PORT 3 IP ADDR NETWK, PRT 1-2 SUBNET OVRLP, PRT 1-3 SUBNET OVRLP,
PRT 2-3 SUBNET OVRLP, > 1 GATEWAY DEFINED
This actual value indicates the validity of the IP parameters applied to the network stack.
For details on the status values, see
for ports 2 and 3 exist only when the D90
Select the Actual Values > Communications > Remaining Connection menu item to open
the remaining TCP/IP connections actual values window.
Figure 80: Remaining TCP/IP connections actual values
The following actual values are available to display the remaining TCP/IP connections.
MMS Available TCP/IP Connections
Range: 0, 1, 2, 3, 4, 5
This actual value indicates the number of connections available for IEC 61850 MMS
communications.
Modbus Available TCP/IP Connections
Range: 0, 1, 2, 3, 4
This actual value indicates the number of connections available for Modbus
communications.
DNP Available TCP/IP Connections
Range: 0, 1, 2
This actual value indicates the number of connections available for DNP
communications. The number of DNP connections is zero unless the "Network - TCP"
value has been selected for both the
settings.
PMU Available TCP/IP Connections
Range: 0, 1
This actual value indicates the number of connections available for the phasor
measurement unit.
IEC Available TCP/IP Connections
Range: 0, 1, 2
This actual value indicates the number of connections available for IEC 60870-5-104
communications.
Ethernet ports on page 90. The Ethernet parameters
Plus
contains a communications card.
and
DNP Channel 1 Port DNP Channel 2 Port
NETWORK SETTINGS
99