GE D90 Plus Instruction Manual page 86

FRONT PANEL OVERVIEW
Communication status page
76
System > Installation menu. The setup program automatically updates the
Date after each setting change. The current D90
annunciator pages, as is the total number of active self-tests and alarms.
The communication status page provides a summary of the currently available TCP/IP
connections for the supported IED protocols. The D90
connections, four Modbus connections, two DNP connections, and one PMU connection. It
should be noted that the DNP connections are only shown as available if the protocol has
been enabled and the D90
each of the available Ethernet ports. Ethernet port 1 is the port on the main CPU card in
slot D, while port 2 is located at the top of the slot C communications processor and port 3
at the bottom. The displayed MAC address is for Ethernet port 1. The MAC address of
Ethernet port 2 is the MAC address of Ethernet port 1 incremented by 1. The MAC address
of Ethernet port 3 is the MAC address of Ethernet port 1 incremented by 2.
Figure 57: Communication status page
Plus
date and time is displayed on all
Plus
restarted. The configured IP protocol values are shown for
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
Configuration
Plus
supports up to five MMS