GE D90 Plus Instruction Manual page 621

CHAPTER 13: SECURITY
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Remote Command Password
Range: up to 12 visible ASCII characters (see restrictions above)
Default: null
The value of the remote command password is specified here. For the password to be
successfully entered, the values in the
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
Remote Setting Password
Range: up to 12 visible ASCII characters (see restrictions above)
Default: null
The value of the remote setting password is specified here. For the password to be
successfully entered, the values in the
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
The access supervision settings allow the user to specify the length of inactivity required
before returning to the restricted access level. The following access supervision settings
are available.
Command Password Access Timeout
Range: 5 to 480 minutes in steps of 1
Default: 5 minutes
This setting specifies the length of inactivity (no local or remote access) required to
return to restricted access from the command password level.
Setting Password Access Timeout
Range: 5 to 480 minutes in steps of 1
Default: 30 minutes
This setting specifies the length of inactivity (no local or remote access) required to
return to restricted access from the setting password level.
Invalid Password Attempts
Range: 2 to 5 in steps of 1
Default: 3
This setting specifies the number of times an incorrect password can be entered within a
three-minute time span before lockout occurs and applies to both the setting and
command passwords.
When lockout occurs for the command password level, the
communication operands are set to "On". These operands are
ACCESS REM CMND DENY
returned to the "Off" state upon expiration of the lockout. Likewise, when lockout occurs
for the setting password level, the
communication operands are set to "On". These operands are also returned to the "Off"
state upon expiration of the lockout.
Password Lockout Duration
Range: 5 to 60 minutes in steps of 1
Default: 5 minutes
This setting specifies the time that the D90
after the number of invalid password entries specified by the
setting has occurred.
and
Enter New Password
and
Enter New Password
ACCESS LOC CMND DENY
and
ACCESS LOC SETG DENY ACCESS REM SETG DENY
Plus
will lockout command password access
PASSWORD SECURITY
Confirm New Password
Confirm New Password
and
Invalid Password Attempts
611