GE D90 Plus Instruction Manual page 130

IEC 61850 COMMUNICATIONS
Remote outputs: DNA bit pairs
120
Item
Range: None, Dataset Item 1 through Dataset Item 64
Default: None
This setting specifies the required bits of the GOOSE message.
Default State
Range: Intermediate, Off, On, Bad, Latest
Default: Latest
This setting selects the default value for the offline remote double-point status input.
Events
Range: Enabled, Disabled
Default: Disabled
This setting enables and disables the logging of remote double-point status input events
in the sequence of events recorder.
Remote outputs (1 to 32) are FlexLogic™ operands inserted into GSSE/GOOSE messages
that are transmitted to remote devices on a LAN. Each digital point in the message must
be programmed to carry the state of a specific FlexLogic™ operand. The above operand
setting represents a specific DNA function (as shown in the following table) to be
transmitted.
Table 7: IEC 61850 DNA Assignments
DNA IEC 61850 definition
1 Test
2 ConfRev
Select the Settings > Communications > IEC 61850 > GSSE/GOOSE Configuration >
Inputs/Outputs > Remote Outputs DNA menu item to open the remote inputs
configuration window.
Figure 97: Remote outputs DNA bit pair configuration settings
The following settings are available for each of the 32 remote outputs.
FlexLogic™ operand
IEC 61850 TEST MODE
IEC 61850 CONF REV
PLUS
D90 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: COMMUNICATIONS