Enervista Security Management System; Enabling The Security Management System; Adding A New User - GE D90 Plus Instruction Manual
Line distance protection system
Hide thumbs
Also See for D90 Plus:
- Instruction manual (688 pages) ,
- Communications manual (222 pages) ,
- Instruction manual (602 pages)
Table of Contents
Advertisement
CHAPTER 13: SECURITY
EnerVista security management system
Enabling the security management system
Adding a new user
PLUS
D90
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
Plus
The D90
provides a means to raise an alarm upon failed password entry. Should
password verification fail while accessing a password-protected level of the relay (either
settings or commands), the
programmed to raise an alarm via contact outputs or communications. This feature can be
used to protect against both unauthorized and accidental access attempts. Therefore, to
apply this feature with security, the command level should be password-protected. The
operand does not generate events.
The EnerVista security management system is a role-based access control (RBAC) system
that allows a security administrator to easily manage the security privileges of multiple
users. This allows for access control of UR
substation and conforms to the principles of RBAC as defined in ANSI INCITS 359-2004.
The EnerVista security management system is disabled by default to allow the
administrator direct access to the EnerVista software after installation. It is recommended
that security be enabled before placing the device in service.
The EnerVista security management system is disabled by default. This allows access to
the device immediately after installation. When security is disabled, all users are granted
administrator access.
1.
Select the Security > User Management menu item to open the user management
configuration window.
2.
Check the Enable Security box in the lower-left corner to enable the security
management system.
Security is now enabled for the EnerVista UR
enter a username and password upon starting the software.
The following procedure describes how to add new users to the security management
system. The following pre-requisites are required to add new users.
ENERVISTA SECURITY MANAGEMENT SYSTEM
operand is asserted. The operand can be
UNAUTHORIZED ACCESS
Plus
-series devices by multiple personnel within a
Plus
Setup software. It will now be necessary to
613
Advertisement
Table of Contents
