Dnp Point Lists - GE Feeder Management Relay 750 Instruction Manual

7.5 DNP COMMUNICATIONS
The following table specifies the default variation for all objects returned by the relay. These are the variations that will be
returned for the object in a response when no specific variation is specified in a request.
DEFAULT VARIATIONS
OBJECT DESCRIPTION
1 Binary Input - Single Bit
2 Binary Input Change With Time
10 Binary Output Status
30 16-Bit Analog Input Without Flag
32 16-Bit Analog Input Change Without Time
a) BINARY INPUT / BINARY INPUT CHANGE
BINARY INPUT (OBJECT 01);
BINARY INPUT CHANGE (OBJECT 02)
INDEX DESCRIPTION
0 Relay In Service
1 Trip Condition(s) Active
2 Alarm Condition(s) Active
3 Protection Picked Up
4 Setpoint Group 1 Active
5 Setpoint Group 2 Active
6 Setpoint Group 3 Active
7 Setpoint Group 4 Active
8 Breaker Is Open
9 Breaker Is Closed
10 Reclosure Enabled
11 Reclosure Disabled
12 Reclosure In Progress
7
13 Reclosure Locked Out
14 Local Mode Active
15 Diagnostic Message(s) Active
16 Major Internal Failure
17 Minor Internal Failure
18 Testing Mode Active
19 Contact Input 1 Closed
20 Contact Input 2 Closed
21 Contact Input 3 Closed
Notes:
1. Any detected change in the state of any point will cause the generation of an event object.
2. An event object will be generated as a result of any change in any point.
7-52
Courtesy of NationalSwitchgear.com
EVENT
CLASS
ASSIGNED
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
1
Class 1
1
Class 1
1
Class 1
1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
750/760 Feeder Management Relay
DEFAULT
VARIATION
1
2
2
4
2
BINARY INPUT (OBJECT 01);
BINARY INPUT CHANGE (OBJECT 02)
INDEX DESCRIPTION
22 Contact Input 4 Closed
23 Contact Input 5 Closed
24 Contact Input 6 Closed
25 Contact Input 7 Closed
26 Contact Input 8 Closed
27 Contact Input 9 Closed
28 Contact Input 10 Closed
29 Contact Input 11 Closed
30 Contact Input 12 Closed
31 Contact Input 13 Closed
32 Contact Input 14 Closed
33 Setpoint Access Jumper Present
34 Coil Monitor 1 Circuit Closed
35 Coil Monitor 2 Circuit Closed
36 Relay 1 TRIP Operated
37 Relay 2 CLOSE Operated
38 Relay 3 AUXILIARY Operated
39 Relay 4 AUXILIARY Operated
40 Relay 5 AUXILIARY Operated
41 Relay 6 AUXILIARY Operated
42 Relay 7 AUXILIARY Operated
43 Relay 8 SERVICE Operated
7 COMMUNICATIONS

7.5.3 DNP POINT LISTS

EVENT
CLASS
ASSIGNED
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
Class 1
GE Multilin