Still Image Operations
For an overview of frame memory concepts, see "Frame Memory" (page 80).
Notes
• During playback of a frame memory clip of the pair assigned to either of the
• The following sections describe the operations available in the MVS-8000A
Preparations
Allocating the frame memory outputs (FM1 to FM8) to cross-
point buttons
To output a frame memory image to a monitor, for example, the output signal
from the frame memory (FM1 to FM8) must be allocated to a cross-point
button. Carry out this allocation in the Setup menu.
Accessing the Frame Memory menu
Most frame memory operations are carried out using the Frame Memory menu.
To access the Frame Memory menu, use either of the following procedures.
• In the menu control block, select the top menu selection button [FRAME
• Press the cross-point button to which the frame memory output is allocated
Interpreting the Frame Memory Menu
The menu screen consists of the following principal parts.
The frame memory selection area display is the same for all except the Pattern
Adjust/Pattern Select/Field Invert/File (excluding Pair Recombination menu)/
Folder/External HDD menus.
438
Still Image Operations
target FM selection buttons (see page 462), frame memory operations may
not be performed properly. Carry out frame memory operations after
stopping clip playback.
system and MVS-8000G system.
The MVS-8000 system uses the same menus as those of Version 5.30. For
its operating procedures, see the User's Guide of Version 6.00 or earlier.
MEM].
twice in rapid succession.