Verifying The Dai Configuration - Cisco Catalyst 2960-XR Security Configuration Manual
Ios release 15.0 2 ex1
Hide thumbs
Also See for Catalyst 2960-XR:
- Configuration manual (196 pages) ,
- Configuration manuals (120 pages) ,
- Reference (52 pages)
Table of Contents
Advertisement
Configuring Dynamic ARP Inspection
Verifying the DAI Configuration
To display and verify the DAI configuration, use the following commands:
Command
show arp access-list [acl-name]
show ip arp inspection interfaces [interface-id]
show ip arp inspection vlan vlan-range
OL-29434-01
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
Verifying the DAI Configuration
Description
Displays detailed information about ARP ACLs.
Displays the trust state and the rate limit of ARP
packets for the specified interface or all interfaces.
Displays the configuration and the operating state of
dynamic ARP inspection for the specified VLAN. If
no VLANs are specified or if a range is specified,
displays information only for VLANs with dynamic
ARP inspection enabled (active).
211
Advertisement
Table of Contents
