Verifying The Lec Configuration; Verifying Atm And Lane Status - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Verifying the LEC Configuration

When you have configure the LEC, the ATM module is ready to transmit and receive data
between your LAN and the ATM network.
Verifying the LEC Configuration
After the LEC is configured, you can verify that the configuration is complete. This section
tells you how to verify the ATM and LANE status and view the port statistics for the LEC.

Verifying ATM and LANE Status

You can verify the ATM and LANE status by using the show lane command.
Using the show lane command
The show lane command verifies that the LEC is operational and shows the ATM NSAP
addresses of the LANE configuration.
To verify ATM and LANE status from the CLI, enter the show lane EXEC command:
ATM> show lane
LE Client ATM1.1 ELAN name: marketing Admin: up
Client ID: 2
Join Attempt: 2
HW Address: 00c0.1dfc.a2fc
VLANID: 1
ATM Address: 39.000000000000000000000000.00C01DFCA2FC.00
VCD rxFrames txFrames
0 0
4 0
5 0
6 0
13 0
8 58
ATM>
3-4
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
LEC up for 6 minutes 14 seconds
Type: ethernet
Type ATM Address
0 configure 39.000000000000000000000000.00605C28DA23.00
2 direct 39.000000000000000000000000.00605C28DA21.01
0 distribute 39.000000000000000000000000.00605C28DA21.01
20 send 39.000000000000000000000000.00605C28DA22.01
0 forward 39.000000000000000000000000.00605C28DA22.01
55 data 39.000000000000000000000000.00605C28DA20.01
State: operational
Max Frame Size: 1516