Plc Configuration - JUMO mTRON T Operating Manual

6 Configuration
6.10

PLC configuration

Up to 50 (as of system version 02: 200) parameters can be defined here for the PLC. These
are only used in the PLC program.
By assigning the name and unit, and by defining limits (min. and max.) and the data type, the
PLC programmer can compile each of the required input masks individually for each parameter
and therefore adapt them to the relevant application.
The screen configured in the setup program is essential for entering parameter values, both in
the setup program and on the multifunction panel.
WARNING!
The relevance of the PLC parameters depends on the PLC program.
Changes to parameters may have unintentional effects.
The parameters should only be changed if an express instruction was given by the manufac-
turer to do so.
Setup dialog
This window shows all parameters with their names and values. Alternatively, only activated
parameters are displayed (checkbox selected).
The name and unit are specified in the input mask; the parameters are also activated there.
The parameter value is entered in this window.
Parameters
Parameter
Parameter active
(P...)
Name
Value
90
Selection/settings
(Display only)
Entry in the "Input mask" menu
Entry in lower field (here: "Parameter 1") Value of the relevant parameter and its
Description
X = Parameter is active
Name that was assigned in the input
mask for the relevant parameter.
If no name is assigned, "Parameter x" is
shown here (x = 1 to 50).
unit
The unit is also specified using the input
mask.