JUMO mTRON T Operating Manual page 139

Parameters Selection/settings
Number 1 to 99999
Allocation Selection of program generators to be used to execute the program.
?
Activated (checkmark)
Not activated
Process steps Select the button
?
Generator Select the button
configuration
Cut Select the button
Copy Select the button
Insert Select the button
Add empty Select the button
line
Delete Select the button
No. Select section from 1 to 100 to be pro-
grammed (starting with section 1)
Process step Select process step from the drop-down
list.
?
Section time 0 to 360000 s
(Max. 59:59:59 hh:mm:ss)
RS 1 to 100
(Repeat section
NoC 0 to 99
(Number of
cycles)
Setpoint 1(1) to -99999 to 0 to +99999
Setpoint 2(10)
The limits depend on the minimum and
?
maximum admissible setpoint values of
the program generator.
Operating Activation of operating contacts by selection (drop-down list)
contacts
Selected (checkmark)
Not selected
9 Program editor
Description
Number of repetitions
(active if "Repetition" = "Number")
Program generator selected
Program generator not selected
Use this button to open the menu for
configuring the process steps.
Use this button to open a menu for con-
figuring the program generators.
Use this button to cut lines (program
sections) that have been marked.
Use this button to copy lines (program
sections) that have been marked.
Use this button to insert lines (program
sections) that have been cut or copied
above a selected line.
Use this button to insert an empty line
above a marked line (program section).
Use this button to delete lines (program
sections) that have been marked.
Number of program section
The process step specifies the limits of
the section time and defines which set-
points are available.
Duration of program section
The section time must be within the lim-
its specified by the process step.
Number of program section that is to be
repeated with the following section.
Number of repetitions of a program sec-
tion (or multiple linked program sec-
tions)
Setpoint 1 to setpoint 10
Only those setpoints can be edited
which are enabled in the process step.
Operating contact is active
Active operating contacts are displayed
in the "Operating contacts" field.
Operating contact is not active
139