Process Engineering (As Of System Version 03) - JUMO mTRON T Operating Manual

6 Configuration
6.11.2

Process engineering (as of system version 03)

The following parameters are available if the option "Program generator with process steps"
(extra code 228) is active.
Setup dialog
Parameters
Parameters
Number of manu-
facturer programs
?
Changeover to
next section
?
96
Selection/settings
0 to 50
Condition for switching to the next program section
Time
Setpoint value
Time and setpoint value
Time or setpoint value
Time != 0 or Setp. != NoInput
Description
Number of manufacturer programs
This parameter is available for program
generator 1 only, but it applies to all pro-
gram generators.
After expiry of section time (setpoint can
be used, but not as criterion for section
changeover)
After reaching the setpoint value (actual
value = setpoint value; section time is
not available)
After expiry of section time AND after
reaching the setpoint value
After expiry of section time OR after
reaching the setpoint value
Either after expiry of section time OR
after reaching the setpoint value