General - JUMO mTRON T Operating Manual

Example of using the operating contacts in the multichannel controller module
1) In the configuration menu for the digital outputs of the multichannel controller module, the
appropriate external signals are selected as signal sources (digital selector, e.g. NV_DO03,
etc.)
2) In the NV connecting list, these external signals (here: NV_DO03, etc. ) are connected to
the operating contact signals of a central processing unit program generator (e.g. operating
contact 1, etc.).
NOTE!
In the setup program, the NV connecting list is in the configuration level of the relevant input/
output module (here: multichannel controller module). In the multifunction panel, there is a
central NV connecting list in the configuration menu of the central processing unit.
NOTE!
If the configuration of a program generator is changed, all program generators that are run-
ning stop and are set to basic status to prevent potential malfunctions.
6.11.1

General

NOTE!
In the multifunction panel 840 the corresponding menu item is named "Prog. generator" in-
stead of "Globals".
Setup dialog
6 Configuration
93