Program Generator - JUMO mTRON T Operating Manual

5 Operation
5.5.1

Program generator

Program generator operation (option) covers the following settings and functions:
• Selecting a program
• Specifying the program section and delay time for program start
• Starting and stopping the program
• Changing the program temporarily
• Changing to manual mode and setting the setpoint values and operating contacts
• Display of setpoint values, operating contacts, program names and sections, tolerance
band signal, and running times; as of system version 03, the number of program repetitions
is also displayed
NOTE!
The channel and setpoint value of the program generator must be assigned to the input sig-
nal (setpoint value) of the relevant controller channel in the controller module NV connecting
list.
Generator screen – overview of the nine program generators
This overview shows the following information for all activated program generators:
• Function: program generator (or current program) or fixed-setpoint generator
• Current program section of first program channel
• Remaining running time of program or of current cycle (in case of a program repetition)
To select a program generator, touch the relevant box. Program generators shown on a gray
background are switched off and cannot be selected. The colors of the background and fore-
ground – except for gray – can be configured for each program generator (central processing
unit).
The "Start/Stop" and "Info" tabs always relate to the selected program generator.
If only one program generator is switched on, the Start/Stop screen of the relevant program
generator is displayed in place of the overview.
46