JUMO mTRON T Operating Manual page 56

6 Configuration
Category
Program
generator 1 to
Program
generator 9
Limit monitoring
Binary linking
Binary PLC out-
put block 13 to
block 18
Alarm analog
variables
Alarm integer
variables
56
Signal
Operating contact 1 to 16
Mode: Basic status
Mode: Automatic
Mode: Automatic 1
Mode: Standstill
Mode: Delay
Mode: Program end
Mode: Manual
Tolerance band channel 1 to 3
Batch control
PLC Binary output 28 to 32
Limit monitoring 1 to 64
Binary linking 1 to 8
PLC Binary output 9 to 32
PLC Binary output 1 to 32
Alarm1 ExAI1 to Alarm1 ExAI64
Alarm2 ExAI1 to Alarm2ExAI64
Alarm1 ExInt1 to Alarm1 ExInt64
Alarm2 ExInt1 to Alarm2ExInt64
Description
Operating contact 1 to 16 of program channels
(in the three program channels, operating con-
tacts with the same name are linked with OR)
Status: Program is not running (basic status)
Status: Program is running (automatic mode,
no delay time or program end time)
Status: Program is running (automatic mode,
incl. delay time and program end time)
Status: Program stopped during automatic
mode (time base stopped)
Status: Program start delayed (delay time
runs)
Status: Program ends (program end time runs,
corresponds to length of end signal)
Status: Manual mode
Tolerance band signal of program channel 1 to
3
Signal to control the batch recording (OR-
linked signals "Automatic", "Standstill", and
"Program end").
Signal of PLC digital output 28 to 32
Output signal of limit value monitoring 1 to 64
Result of binary linking 1 to 8
Signal of PLC digital output 9 to 32
Signal of PLC digital output 1 to 32
Alarm signal 1 of analog variable 1 to 64
Alarm signal 2 of analog variable 1 to 64
Alarm signal 1 of integer variable 1 to 64
Alarm signal 2 of integer variable 1 to 64