JUMO mTRON T Operating Manual page 134

9 Program editor
Parameter
NoC
(Number of
cycles)
?
Setpoint 1 to 4
Tol low
(Lower limit of tol-
erance band)
?
Tol high
(Upper limit of tol-
erance band)
?
Operating
contacts
OK
OK with check
Program name, channel name
NOTE!
The name can be entered in two languages, but only the text in language 1 is transmitted to
the device. Language switching at the device has no effect on this text. Optionally, the lan-
guage order before transmission needs to be changed.
134
Selection/settings
0 to 99
-99999 to 0 to +99999
The limits depend on the minimum and
maximum admissible setpoint values 1
to 4 of the program generator.
-99999 to 0 to +99999
The limits depend on the minimum and
maximum admissible lower limit of the
tolerance band for the program genera-
tor.
-99999 to 0 to +99999
The limits depend on the minimum and
maximum admissible upper limit of the
tolerance band for the program genera-
tor.
Activation of operating contacts by selection (drop-down list)
Selected (checkmark)
Not selected
Select the button
Select the button
Description
Number of repetitions of a program sec-
tion (or multiple linked program sec-
tions)
Setpoint value 1 to setpoint value 4
The texts of the program generator with
the lowest number (1 to 9) are used as
designations for the setpoints.
Lower limit value for tolerance band
monitoring of setpoint value 1
Upper limit value for tolerance band
monitoring of setpoint value 1
Operating contact is active
Active operating contacts are displayed
in the "Operating contacts" field.
Operating contact is not active
Before the entered values are accepted,
it is checked whether the setpoint values
and the tolerance band limits lie within
the limits which have been defined in the
program generator configuration.
The whole program plan is checked
whether the limits which have been
defined in the program generator confi-
guration are not exceeded.