Parameterization; Plc Parameter - JUMO mTRON T Operating Manual

NOTE!
The parameters described in this section can be configured either with the setup program, or
on the multifunction panel.
7.1

PLC parameter

Up to 50 (as of system version 02: 200) parameters can be defined here for the PLC (parameter
level). These are only used in the PLC program.
By assigning the name and unit, and by defining limits (min. and max.) and the data type, the
PLC programmer can compile each of the required input masks individually for each parameter
and therefore adapt them to the relevant application.
The screen configured in the setup program is essential for entering parameter values, both in
the setup program and on the multifunction panel.
WARNING!
The relevance of the PLC parameters depends on the PLC program.
Changes to parameters may have unintentional effects.
The parameters should only be changed if an express instruction was given by the manufac-
turer to do so.
Setup dialog
This window shows all parameters with their names and values. Alternatively, only activated
parameters are displayed (checkbox selected).
The name and unit are specified in the input mask; the parameters are also activated there.
The parameter value is entered in this window.
Parameters
Parameter
Parameter active
(P...)
Selection/settings
(Display only)

7 Parameterization

Description
X = Parameter is active
113