JUMO mTRON T Operating Manual page 127

Parameter Selection/settings
Enabled setpoints All
Open drop-down menu for disabling or
enabling.
Assigned genera- None
tors
Select program generator from the drop-
down menu.
Process contacts None
?
System version 02: Open drop-down
menu for activation or deactivation.
As of system version 03: Select button
"..." for activation, for deactivation, and
for the selection of the function.
Copy Select the button
8 Configuration – in setup program only
Description
Enabled setpoints can be used in the
program editor.
A setpoint which is used as a criterion
for the section changeover is always
available in the program editor (even if it
is not enabled here).
The process step is assigned to one or
more program generators and therefore
is available in the program editor.
Process contacts are used to control
PLC functions.
Use this button to copy lines (process
steps) that have been marked.
127