JUMO mTRON T Operating Manual page 140

9 Program editor
Parameters
OK
OK with check
Program name
NOTE!
The name can be entered in two languages, but only the text in language 1 is transmitted to
the device. Language switching at the device has no effect on this text. Optionally, the lan-
guage order before transmission needs to be changed.
Repetition
A program is completely repeated after the expiry of the last section. The setpoint values jump
from the value in the last section to the value in the first section regardless of the specification
(step or ramp).
Repetitions of program sections are executed even when a program is repeated.
Temporary changes during a program run will be also performed during the following program
repetitions. Program repetitions cannot be changed temporarily.
A delayed program start affects only the first program run and does not affect the program rep-
etition. The end signal becomes active when all repetitions are over.
The signal for batch control is activated at program start and remains active until the last pro-
gram repetition is finished or until the program is aborted manually.
Running program repetitions are maintained after a power failure and will be further processed.
Allocation
To execute a program, at least one program generator must be selected. A program can be
executed on up to 9 program generators at the same time.
The setpoint values are checked for compliance with the input limits of all the selected program
generators (even if temporarily entered).
If several programs are executed at the same time then different program generators must be
assigned to these programs.
The section changeover of the program generator with the lowest number (1 to 9) is used in
the program schema. By clicking "OK with check" button, all sections are checked for compli-
ance with the criteria for section changeover. This check considers all selected program gen-
erators.
The allocation of program generators affects which process steps are selectable.
140
Selection/settings
Select the button
Select the button
Description
Before the entered values are accepted,
it is checked whether the setpoint values
and the tolerance band limits lie within
the limits which have been defined in the
program generator configuration.
The whole program plan is checked
whether the limits which have been
defined in the program generator confi-
guration are not exceeded.