Startup And Configuration - JUMO mTRON T System Description

A setup program is available for the measuring, control, and automation system. The setup pro-
gram must be used for system startup; the first step is to perform project configuration. For ex-
ample, this also includes:
• Creating a project and selecting the first module (e.g. central processing unit)
• Creating the hardware assignment. In other words, selecting the remaining modules includ-
ing the optional extensions (inputs/outputs, interfaces)
• Selecting special software and hardware versions, if required
• Activating optional functions (e.g. math/logic, PLC)
• Settings and texts for collective alarms (system and modules)
• Project-specific settings (e.g. project description, language selection, collective alarm, PLC
application, time zone)
• User administration
Following the project configuration, the individual modules and the multifunction panel must be
configured. This task is also performed using the setup program. For example, this includes the
configuration (and/or parameterization) of the following functions:
• Inputs and outputs, interfaces, internal signals
• Limit value monitoring
• Controller
• Math/logic (option)
• Program generator (option)
• PLC (option)
• Recording function (option)
With a few exceptions, the configuration of the modules can also be performed on the multi-
function panel. A prerequisite for this is that the hardware assignment was created using the
setup program and transferred to the system.
The following manual contains information on the configuration and startup of the overall mea-
suring, control, and automation system:
Manual, setup program B 705000.6
In this manual, the user can find a simple example that describes the basic procedure during
the initial startup of the measuring, control, and automation system.
In addition, a separate operating manual is available for each module; it describes the config-
uration of the module.
Chapter 1.4 "Available technical documentation", page 21
Both of the following sections are only intended to provide a brief insight into the setup program
and the multifunction panel. For more information, see the respective manual.

7 Startup and configuration

63