JUMO mTRON T Operating Manual page 52

5 Operation
Generator screen – information about the selected program generator
(6)
(1) Setpoint values
(3) Tolerance band signal of setpoint value 1
(5) Switch to next program channel (if avail-
able)
16 operating contacts can be defined in each of the three program channels (maximum three
program channels). These are linked with OR, so that 16 operating contacts are available for
each program generator.
Operating with barcode scanner
Operating the program generator is also possible by reading barcodes; the following functions
are supported:
• Program selection (program number 1 to 99)
• Program start
• Program stop
The corresponding barcodes can be found in the operating manual of multifunction panel 840
(B 705060.0).
52
(2) Operating contacts
(4) Runtimes
(6) Current program section
(1)
(2)
(3)
(4)
(5)