JUMO mTRON T Operating Manual page 97

Parameters
Setpoint for sec-
tion changeover
Number of manufacturer programs
This parameter determines how many programs can only be edited by the system manufactur-
er.
Manufacturer programs can only be edited with the full version of the setup program. It is not
possible to edit these programs in the setup program with "Program editor" license or on the
multifunction panel 840; here these programs are only displayed. Manufacturer programs start
with program number 1. When entering the number 5, for example, programs 1 to 5 are man-
ufacturer programs.
Changeover to next section
Selection "Time != 0 or Setp. != NoInput": Either the section time or the setpoint value can be
entered in the program schema. This is the same behavior as in system version 02, but in sys-
tem version 03 the setpoint can be selected (system version 02: setpoint 2).
Selection/settings
Setpoint 1 to Setpoint 10
6 Configuration
Description
Setpoint for section changeover
Setpoint which is decisive for section
changeover (core setpoint value, com-
pared to actual value)
97