JUMO mTRON T Operating Manual page 49

Generator screen – program running
(11)
(10)
(9)
(1) Program name and number of current pro-
gram section in channel 1;
number of cycles (program repetitions;
as of system version 03)
(3) Switch position of operating contacts
(5) Skip to next program section of channel 1
(carried out for channel 2 and 3 at same
time if present)
(7) Skip to previous program section of chan-
nel 1 (carried out for channel 2 and 3 at
same time if present)
(9) Temporary change to program with pro-
gram editor
(11) "Program running" display
The appearance of (2), (3), (4), and (10) can be configured: selection of the signals (or of run-
ning time) and the color, assignment of name and unit.
NOTE!
Temporary changes to setpoint values on the multifunction panel are only displayed on the
generator screen for running programs. If the program is paused, temporary changes are ap-
plied, but not displayed. The changes do not take effect and are not shown on the generator
screen until the program continues to run.
NOTE!
Cycles (program repetitions) are displayed only if this function has been activated in the pro-
gram schema (endless or number). During the first program run, the current cycle is 0, while
1 is displayed during the first repetition. If a number of repetitions has been set in the program
schema, the number is also displayed. Example: 3/10 means that the program is currently in
the third of ten repetitions (i.e. in the fourth program run).
(8)
(2) Current setpoint value of program genera-
tor (here: setpoint value 1 of channel 1)
(4) Remaining running time of program
(6) Abort program
(8) Pause program
(10) Running time of program that has elapsed
5 Operation
(1)
(2)
(3)
(4)
(5)
(6)
(7)
49