JUMO mTRON T Operating Manual page 136

9 Program editor
Generator configuration
Use the "Generator configuration" button to open this window:
The individual sub-items and parameters for generator configuration depend on the system
version and are described in this section:
Chapter 6.11 "Program generator", page 92
No.
To create a program, the individual program sections are programmed consecutively. Up to 100
program sections can be defined in this way.
Program sections can be copied, inserted at different positions, and edited if necessary.
RS, NoC
The program sections to be repeated form a repeat cycle. The number of cycles (NoC) and the
start of the repeat section (RS) are programmed in the last program section of a repeat cycle.
Example:
Program sections 2 to 4 are repeated once. Therefore, the following settings must be made in
section 4:
NoC (number of cycles) = 1
RS (repeat section) = 2
w
1 to 6 Program sections
136
1 2 3 4 2
C
3 4 5
C Repeat cycle
6
t