Configuration; Selectors; Analog Selector - JUMO mTRON T Operating Manual

NOTE!
The parameters described in this section can be configured either with the setup program, or
on the multifunction panel (exception: setup info in the device data).
6.1

Selectors

The selectors contain all analog and digital signals that are available for configuration in the
central processing unit.
These are, firstly, the central processing unit (CPU) signals. This relates to internal signals (incl.
PLC) and variables. The values of the variables are read in via an interface, such as Com1.
 Chapter 6.3 "Variables", page 63
 Chapter 8.2 "Modbus frames for reading", page 120
Secondly, they are signals originating from the input/output modules (incl. multichannel control-
ler module) and multifunction panel. As of system version 04, the signals of the thyristor power
controller (type 70906x) are also available in the selectors.
6.1.1

Analog selector

The following table lists all analog signals.
Category
Inactive
Central processing unit
Analog variables
Program
generator 1 to
Program
generator 9
Analog PLC out-
put block 10 to
block 18
Signal
Analog variable 1 to 64
Channel 1 SP1 to Channel 3 SP1 Setpoint value 1 of program channel 1 to 3
Channel 1 SP2 to Channel 3 SP2 Setpoint value 2 of program channel 1 to 3
Channel 1 SP2 to Channel 3 SP2 Setpoint value 3 of program channel 1 to 3
Channel 1 SP4 to Channel 3 SP4 Setpoint value 4 of program channel 1 to 3
PLC Analog output 13 to 16
PLC Analog output 1 to 16

6 Configuration

Description
No signal selected
Analog variable 1 to 64 (via interface)
Signal of PLC analog output 13 to 16
Signal of PLC analog output 1 to 16
53