Setup Program - JUMO mTRON T System Description

Measuring, control, and automation system

Hide thumbs Also See for JUMO mTRON T:

Table of Contents

7 Startup and configuration

7.1

Setup program

The setup program (accessories) is installed on a PC and connected to the base unit (e.g. cen-

tral processing unit) via a USB or LAN interface. In this way, the entire system can be conve-

niently configured, parameterized, and operated. The setup data is transferred from the base

unit via the system bus to the connected input/output modules, of which there may be a maxi-

mum of 30, even if these are connected via a router module. The base unit continuously com-

pares the saved system configuration with the input/output modules that are present. For this

reason, a module insert of an identical type can simply be replaced when service work is being

performed. The new module insert is automatically detected by the base unit and configured

(Plug and Play).

Manual, setup program B 705000.6

NOTE!

The setup program is an essential requirement for the initial startup and also for making

changes to the hardware assignment. Certain parameters of the modules and the multifunc-

tion panel can also only be configured using the setup program.

Table of Contents