Adjusting Mix Levels - Extron electronics mediaport 200 User Manual

Mix to Far End panel — Contains controls for mic and program levels, which create
D
the mix that goes to the far end.
Set these levels during a soft conference call, utilizing verbal feedback from individuals
located at the far end. You can view the signal level of this audio mix using the meters at
the bottom of the
Audio Config
If the input gain is set up properly, setting levels higher than 0 dB is generally not
necessary. You can set program audio to the same level as mic audio, or slightly lower.
If program audio is played at the same time that someone is talking, use ducking
to lower the program audio level during speech. The ducking processor returns the
program audio to its original level when talking stops.

Adjusting Mix Levels

To access the PCS software
1. On the PCS main window, click the
2. On the
displayed.
Figure 64.
The following adjustments are available from the
Setting the room volume
On the
Mix
1. Set the
start playback.
2. Play the program sources, one at a time.
panel on the
USB
button, then the
Output
screen:
Mix
screen, click the
Audio Configuration
Settings on the Mix Screen
screen, set the following master faders as follows:
master fader (see figure 64,
Room Volume
screen (on the PCS main window, click the
Output
tab.
button (see figure 64,
Audio Config
tab ( ). The
Mix 2
screen:
Mix
) to -20 dB. This is a safe level to
5
MediaPort 200 • Audio Application Setup
) .
1
screen is
Mix
96