Table of Contents
Advertisement
Replacing DMD fan
The DMD fan provides air cooling for DMD module.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board.
See
Replacing the main board
3. Remove the combiner module.
See
Replacing the combiner module
4. Remove the light engine.
See
Replacing the light engine
5. Remove two screws with a Phillips #1 screwdriver securing DMD fan.
6. Separate the fan and fan holder.
7. Replace the DMD fan.
8. To re-install the fan modules, follow these steps in reverse order.
Replacing P/W fan
The P/W fan draw the air into the projector and provides exhaust cooling for cooling module.
1. Remove the top cover.
See See
Removing the top cover
2. Remove the speaker.
See
Replacing the speaker
3. Remove the rear cover.
See
Removing the rear cover
4. Remove the left-side cover.
See
Removing the left-side cover
5. Remove the right-side cover.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
on page 77.
on page 73.
on page 71.
on page 46.
on page 66.
on page 49..
on page 47..
Ventilation and cooling
53
Advertisement
Table of Contents
