Wireless Security Commands; Auth - SMC Networks EliteConnect SMC2552W-G2 User Manual

7
Command Line Interface

Wireless Security Commands

The commands described in this section configure parameters for wireless security
on the 802.11g interface.
Command

auth

encryption
key
transmit-key
cipher-suite
mic_mode
wpa-pre-shared- key
pmksa-lifetime
pre-authentication
auth
This command defines the 802.11 authentication type allowed by the VAP interface.
Syntax
auth <open-system | shared-key | wpa | wpa-psk | wpa2 | wpa2-psk |
wpa-wpa2-mixed | wpa-wpa2-psk-mixed | > <required | supported>
• open-system - Accepts the client without verifying its identity using a
shared key. "Open" authentication means either there is no encryption (if
encryption is disabled) or WEP-only encryption is used (if encryption is
enabled).
• shared-key - Authentication is based on a shared key that has been
distributed to all stations. If encryption is enabled, "shared" authentication
uses WEP-only encryption.
• wpa - Clients using WPA are accepted for authentication.
• wpa-psk - Clients using WPA with a Pre-shared Key are accepted for
authentication.
• wpa2 - Clients using WPA2 are accepted for authentication.
7-114
Table 7-19. Wireless Security Commands
Function
Defines the 802.11 authentication type allowed by the
access point
Defines whether or not WEP encryption is used to
provide privacy for wireless communications
Sets the keys used for WEP encryption
Sets the index of the key to be used for encrypting
data frames sent between the access point and
wireless clients
Selects an encryption method for the global key used
for multicast and broadcast traffic
Specifies how to calculate the Message Integrity
Check (MIC)
Defines a WPA preshared-key value
Sets the lifetime PMK security associations
Enables WPA2 pre-authentication for fast roaming
Mode Page
IC-W-VAP 7-118
IC-W-VAP 7-117
IC-W 7-118
IC-W-VAP 7-119
IC-W-VAP 7-120
IC-W 7-121
IC-W-VAP 7-122
IC-W-VAP 7-122
IC-W-VAP 7-123