Wireless Security Commands; Table 24: Wireless Security Commands - SMC Networks E21011 User Manual

27
auth
W S
IRELESS
The commands described in this section configure parameters for wireless
security on the VAP interfaces.

Table 24: Wireless Security Commands

Command Function
auth Defines the 802.11 authentication type allowed by
the access point
encryption Defines whether or not WEP encryption is used to
provide privacy for wireless communications
key Sets the keys used for WEP encryption
transmit-key Sets the index of the key to be used for encrypting
data frames sent between the access point and
wireless clients
cipher-suite Selects an encryption method for the global key
used for multicast and broadcast traffic
wpa-pre-shared-key Defines a WPA preshared-key value
pmksa-lifetime Sets the lifetime PMK security associations
make-security-effective Implements wireless security changes made in
current CLI session
This command configures authentication for the VAP interface.
S
YNTAX
auth <open-system | shared-key | wpa | wpa-psk | wpa2 |
wpa2-psk | wpa-wpa2-mixed | wpa-wpa2-psk-mixed>
open-system - Accepts the client without verifying its identity
using a shared key. "Open" authentication means either there is no
encryption (if encryption is disabled) or WEP-only encryption is used
(if encryption is enabled).
shared-key - Authentication is based on a WEP shared key that
has been distributed to all stations.
wpa - Clients using WPA are accepted for authentication.
wpa-psk - Clients using WPA with a Pre-shared Key are accepted
for authentication.
wpa2 - Clients using WPA2 are accepted for authentication.
wpa2-psk - Clients using WPA2 with a Pre-shared Key are
accepted for authentication.
– 214 –
C
ECURITY OMMANDS
Mode Page
IC-W- 217
VAP
IC-W- 216
VAP
IC-W 217
IC-W- 218
VAP
IC-W- 219
VAP
IC-W- 220
VAP
IC-W- 221
VAP
IC-W- 221
VAP