Ethernet Interface Commands; Table 22: Ethernet Interface Commands - SMC Networks E21011 User Manual

25
interface ethernet
E I
THERNET
The commands described in this section configure connection parameters
for the Ethernet port and wireless interface.

Table 22: Ethernet Interface Commands

Command Function
interface ethernet Enters Ethernet interface configuration mode
dns Specifies the primary and secondary name
servers
ip address Sets the IP address for the Ethernet interface
ip dhcp Submits a DHCP request for an IP address
shutdown Disables the Ethernet interface
show interface Shows the status for the Ethernet interface
ethernet
This command enters Ethernet interface configuration mode.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
E
XAMPLE
To specify the 1000BASE-T network interface, enter the following
command:
AP(config)#interface ethernet
AP(if-ethernet)#
– 195 –
C
NTERFACE OMMANDS
Mode Page
GC 195
IC-E 196
IC-E 196
IC-E 197
IC-E 198
Exec 198