Communication Setup; Power Management Setup; Jump Menus; 6600 Mains Failure Frequency - Deif Multi-line 2 Designers Reference Handbook

AGC

6600 Mains failure frequency

No. Setting
6601 Mains failure f
6602 Mains failure f
6603 Mains failure f
6604 Mains failure f

6610 Mains breaker control

No. Setting
6611 MB control
6612 MB control
6613 MB control
6614 MB control
6615 MB control
No parameters can be adjusted in this menu in a standard unit. If the options G5 or H2-H6 are
selected, menus are available. Please refer to the option descriptions.
No parameters can be adjusted in this menu in a standard unit. If the option G5 is selected,
menus are available. Please refer to the option G5 manuals.
A number of menus can only be entered using the jump menu.
9000 Software version
Information about the actual software downloaded to the unit. Please check this before
contacting DEIF regarding service and support matters.
9020 Service port
The RS232 service port can be set up to use the ASCII communication. The ASCII
communication is used when the utility software is connected through a modem.
Selection '0' must be used for cable connection between the AGC and the PC.
Selection '1' must be used for modem connection between the AGC and the PC.
911X User password
The user password menu can only be entered using the "JUMP" push-button.
No. Setting
9116 User password
9117 Service password
9118 Master password
It is recommended to change the password levels of the user, service and
master password, if access to parameter settings must be restricted.
DEIF A/S
Min. setting
Fail. delay 1.0 s
Mains OK delay 10 s
Low frequency 80.0%
High frequency 100.0%
Min. setting
Function Mode shift
OFF
Timer t 0.0 s
MBC
Back synchroni- OFF
sation
Sync. to mains OFF
MB load time 0.0 s

Communication setup

Power management setup

Jump menus

Min. setting
Setting 0
YYYYY Setting 0
XXXXX Setting 0
Designer's Reference Handbook
Max. setting Factory
setting
990.0 s 5.0 s
9900 s 60 s
100.0% 95.0%
120.0% 105.0%
Max. setting Factory
setting
Mode-AMF- Mode shift
Mode OFF
30.0 s 0.5 s
ON OFF
ON ON
30.0 s 0.0 s
Max. setting Factory
setting
32000 2000
32000 2001
32000 2002
Page 169 of 168