Short-Time Parallel - Deif Multi-line 2 Designers Reference Handbook

AGC
Input name
Fire pump
Access lock
Running feedback
Remote start
Remote stop
Semi-auto
Test
Auto
Manual
Block
Remote GB ON
Remote GB OFF
Remote MB ON
Remote MB OFF
Remote TB ON
Remote TB OFF
Remote alarm acknowledge
Gen-set start sequence
Remove starter
Reset analogue governor output
Manual GOV up
Manual GOV down
Manual AVR up
Manual AVR down
Alarm inhibit
GB position ON
GB position OFF
MB position ON
MB position OFF
Emergency stop
External engine failure
AOP buttons
The purpose of the short time parallel function is to be able to define a maximum paralleling time
between the generator and the mains supply.
The function is typically used, if there are local requirements to maximum allowed paralleling
time.
The short time paralleling function is only available in the automatic mains
failure and load take over gen-set modes.
DEIF A/S
Input status Comment
Active
Active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active
Active

Short-time parallel

Designer's Reference Handbook
Page 79 of 168