6060 Gen-Set Modes; 6070 Date And Time (Internal Clock) Setting; 6080 Counters; 6090 Service Timer - Deif Multi-line 2 Designers Reference Handbook

AGC

6060 Gen-set modes

No. Setting
6061 Gen-set mode
Gen-set mode
Gen-set mode
Gen-set mode
Gen-set mode
Gen-set mode

6070 Date and time (internal clock) setting

The date and time can easily be synchronised with the present time and date
from the utility software.
No. Setting
6071 Date and time
6072 Date and time
6073 Date and time
6074 Date and time
6075 Date and time
6076 Date and time

6080 Counters

The settings below (except kWh) are offset values that need to be adjusted at the
commissioning if the display is used for reading the values. A breaker operation is counted each
time the breaker closes.
The setting 'reset kWh counter' resets the value of the produced kWh.
No. Setting
6081 Counters
6082 Counters
6083 Counters
6084 Counters
6085 Counters

6090 Service timer

The function of the service timer enables the user to get an alarm when service of the gen-set is
needed. The timer is reset when the alarm is acknowledged or when the timer is disabled and
enabled again.
No. Setting
6091 Service timer
6092 Service timer
6093 Service timer
6094 Service timer
6095 Service timer
DEIF A/S
Island operation
AMF
Peak shaving
Fixed power
Mains power export
Load take over
Year
Month
Day
Weekday
Hour
Minute
Running time
GB operations
MB operations
kWh
Start attempts
Setpoint
Relay output A
Relay output B
Enable
Fail class
Designer's Reference Handbook
Setting
Island operation
AMF
Peak shaving
Fixed power
Mains power export
Load take over
Min. setting Max. setting
2001 2100
1 12
1 31
1 7
0 23
0 59
Min. setting Max. setting
0 20000
0 20000
0 20000
OFF ON
0 20000
Min. setting Max. setting
0 h 9000 h
R0 (none) Option
R0 (none) dependent
OFF ON
Alarm (1) Trip MB (6)
Factory
setting
-
AMF
-
-
-
-
Factory
setting
Depending on
the software
version
Factory
setting
0
0
0
OFF
0
Factory
setting
500 h
R0 (none)
R0 (none)
ON
Warning (2)
Page 164 of 168